Don't like advertisements? Neither do we. Check out our Premium Membership to support GlobalTuners and get rid of the advertisements!
Propagation Info

Introduction to HF Propagation

In a region extending from a height of about 50 km to over 500 km, some of the molecules of the atmosphere are ionised by radiation from the Sun to produce an ionised gas. This region is called the ionosphere.

Ionisation is the process in which electrons, which are negatively charged, are removed from (or attached to) neutral atoms or molecules to form positively (or negatively) charged ions and free electrons. It is the ions that give their name to the ionosphere, but it is the much lighter and more freely moving electrons which are important in terms of high frequency (HF: 3 to 30 MHz) radio propagation. Generally, the greater the number of electrons, the higher the frequencies that can be used. During the day there may be four regions present called the D, E, F1 and F2 regions. Their approximate height ranges are:

  • D region 50 to 90 km;
  • E region 90 to 140 km;
  • F1 region 140 to 210 km;
  • F2 region over 210 km.

During the daytime, sporadic E (section 1.6) is sometimes observed in the E region, and at certain times during the solar cycle the F1 region may not be distinct from the F2 region but merge to form an F region. At night the D, E and F1 regions become very much depleted of free electrons, leaving only the F2 region available for communications; however it is not uncommon for sporadic E to occur at night.

Only the E, F1, sporadic E when present, and F2 regions refract HF waves. The D region is important though, because while it does not refract HF radio waves, it does absorb or attenuate them.

The F2 region is the most important region for high frequency radio propagation as,  it is present 24 hours of the day.  Its high altitude allows the longest communication paths, it usually refracts the highest frequencies in the HF range.

The lifetime of electrons is greatest in the F2 region which is one reason why it is present at night. Typical lifetimes of electrons in the E, F1 and F2 regions are 20 seconds, 1 minute and 20 minutes, respectively.

Latest full-field Solar Images


These images are current views of the sun shown at different wavelengths of light as taken by SOHO and the Yohkoh soft-Xray telescope.  Click on any thumbnail to view a larger image.
Fe IX/X 171 Å
Fe XII 195 Å
Generally, more bright regions on the disk indicates more solar activity, which usually leads to higher solar flux levels
(which usually leads to better propagation!).
He II/Si XI 304 ÅFe XV 284 Å
Aurora is caused by interaction between the Earth's magnetic field and the solar wind 
(a mix of charged particles blowing away from the sun). 
During solar storms, enough of these charged particles make it through to the Earth's upper atmosphere that they interact with the earths natural magnetic field lines. When enough of these particles collide, energy is released in the form of auroral light. 
In addition to creating a pretty light show (mostly in upper latitudes), radio signals scatter off of these particles and can greatly enhance propagation on 6 meters and above. High levels of aurora can also make propagation via polar routes difficult.

Solar X-ray Flux

This plot shows 3-days of 5-minute solar x-ray flux values measured on the SWPC primary and secondary GOES satellites. One low value may appear prior to eclipse periods. Click on the plot to open an updating secondary window.

There used to be an image here, but it has disappeared from the internet.

D-Region Absorption Prediction Map

This images dynamically updates once a minute. specialy designed by NOAA National Weather and Space Service Prediction Center.
for HF Radio communications prediction. Click on any thumbnail to view a larger image.

There used to be an image here, but it has disappeared from the internet.
"Real-Time Northern Hemisphere Auroral Activity"
"Real-Time Southern Hemisphere Auroral Activity"

© 2007-2018 Ivo Smits, UCIS Internet - About GlobalTuners & Contact - Page generated in 5 ms. 0 SQL queries used.
We use cookies to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners who may combine it with other information you’ve provided to them or they’ve collected from your use of their services. Click here for more information.